Bayer Material Anti-scratch Plastic Polycarbonate Roofing Solid Sheet

Product Introduction

To the requirement of the thickness solid polycarbonate sheet is most strict in all transparent material, because the thickness of the sheet directly affects its performance in a variety of using environment, mainly reflected in the impact resistance and service life. Therefore, it is necessary to master the correct method for measuring solid polycarbonate sheet thickness.

First, correct the caliper or tape measure to the position of "0". Prepare the solid polycarbonate sheet products that need to be measured, carefully remove the protective film covering the upper part of the solid polycarbonate sheet, and make sure there is no foreign matter on the sheet. then stuck The measuring caliper horizontally into the solid polycarbonate sheet, gently press the caliper button to observe and record the number on the caliper.

Remember the steps above, in accordance with this method test two or three points in the four solid polycarbonate sheet edges separately, this add up to at least 8 to 12 points needed to be measured , then make the average number of each point data thus we get the relatively accurate solid polycarbonate sheet thickness, and compare with the custom sheet thickness. If the error is within 3%, it is qualified. For example, a 1 mm solid polycarbonate sheet should be between 0.97 mm and 1.03 mm, and a 10 mm solid polycarbonate sheet should be within a range of 9.7 mm and 10.3 mm.