PC board bending, as the name implies, PC board in the bending machine under the mold or the pressure under the mold, the first after the elastic deformation, and then into the plastic deformation, plastic bending in the initial stage, PC sheet is free to bend. With the upper or lower mold pressure on the sheet metal, the sheet material and the lower mold V-groove gradually close the inner surface, while the radius of curvature and the bending force arm gradually becomes smaller, continue to pressurize until the stroke ends, the upper and lower mold Close contact with the plate at three o'clock, this time to complete a V-bend, which is commonly known as our bend.

Bending this common PC board processing technology, simple operation, with automatic and manual two automatic state, automatic function, plate delivery, within a preset time, automatic bending forming. Soften the gap can be adjusted according to the thickness of the processing plate. Plates with a fixed heating, so that the deformation after forming smaller. Through the hand wheel angle setting, convenient, accurate, configured by the foot to ensure the unity of bulk products. The use of infrared heating method, heating wire furnace greatly extended service life. For voltage can be adjusted from the surface to avoid the thick plate when the paste phenomenon. Configure the water circulation system, increase the cooling rate, and install water temperature overheating alarm system to reduce the defective rate to ensure the safe use of equipment. Leakage protection, coupled with the ground wire to ensure the construction, the use of safety.